Browse Categories
Shopping Cart
Your cart is empty.

Northwood PF-9 Trigger KIT (Anodized)


MSRP: $59.00
Price: $47.20
You Save: $11.80 (20 %)
In Stock
Item Number: ATPF9A-K
ATPF9A-K

Northwood Trigger (Anodized) -
Conversion
KIT    for Kel-Tec PF-9*
*Except for the anodized trigger, the kit components are the same as standard Northwood Trigger Kit.
Trigger has been processed with Type III, Class 2, "Hard Anodize" mil-spec finish.

Kit includes:
  (1) Aluminum Trigger #ATPF9A (Black Anodized)

  (1) Trigger Pin #PF9-253
  (1) Stainless #6-32 x 3/16" Nylock Setscrew
  (1) 2mm  Pin Punch
  (1) 3mm  Pin Punch
  (1) 1/16" Allen Hex Key

Please review the PF-9 Trigger Installation Guide  (link at upper left) before purchasing this product.

Northwood Components does not perform installations or repairs. (See Installation FAQ link at left.)

Product Reviews

(8 Ratings, 4 Reviews) Average Rating:
ratingratingratingratingrating
ratingratingratingratingrating
The Wait for This Trigger Upgrade was Worth It
Bob the Bear (Katy, TX) 3/2/2016 3:11 PM
Received the PF-9 Trigger Kit (Anodized) within three days. I followed the excellent instructions and completed the installation within three hours. It took this long because I had to sand the sub-frame to allow more pre-travel and sound trigger reset. Per instructions, I wrapped 240 grit wet/dry paper around a Bic pen and removed about an 1/8 of an inch. No additional adjustment was required to insure pistol functioned properly. The result was a smooth consistent trigger pull and break with little or no over travel. Pre-travel was 1/8 of an inch. Trigger pull weight was unchanged at six pounds. The kit was an excellent value. What an improvement. Thank you
ratingratingratingratingrating
Major improvement!
Jon Whittecar (Salem, OR) 9/1/2015 5:33 PM
Don't think twice about this trigger just buy it! It took me a total of 20 minutes to install. Luckily I didn't have to sand anything. The initial feel of this trigger makes it feel like a completely different weapon. Thanks for a awesome trigger!
ratingratingratingratingrating
Great Trigger!
Gary Rockol (Pachuta, MS) 7/29/2014 6:55 AM
Installation was a snap. The trigger fits like a glove and gives my pf9 a great new feel. I cant wait to take it out to the range.
ratingratingratingratingrating
Very Nice
Casey (Chillicothe, OH) 3/28/2013 4:07 PM
Waited for the black version. Took 2 hours start to finish. Couple hiccups but nothing to do with the trigger (roll pin holding the spring into the hammer spring retainer went FLYING when I was trying to put it back in). Everything went in smooth, no sanding or anything like that needed. Although I had the newer style PF-9 with the barbed trigger pin, and had to cut out the plastic trigger. But that was also mentioned in the guide. Very very nice improvement!